Table of Contents
Advertisement
Steps
1. Peel the adhesive tape and disconnect the sensor-board cable from the connector on the system board.
2. Unroute the antenna cables from the routing guide.
3. Remove the two (M2x3) screws that secure the eDP cable bracket to the system board.
4. Lift the eDP cable bracket away from the system.
5. Peel the tape that secures the display cable to the system board.
6. Using the pull tab, disconnect the display cable from the connector on the system board.
7. Disconnect the eDP cable from the connector on the system board and unroute it from the routing guide.
8. Remove the six (M2.5x5) screws that secure the display hinges to the system board.
9. Open the display assembly to a 180 degree and flip over the computer, and then place the computer on a flat surface.
10. Remove the display assembly off the computer.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
80
Removing and installing components
Advertisement
Table of Contents
