Connection To The Amplifier; Mains Power Connection; Fitting The Lid; Switching On And Off - Pro-Ject Audio Systems X8 Instructions For Use Manual

Table of Contents

CONNECTION TO THE AMPLIFIER

The record player use an output through a 5-pole DIN connector (18). Use supplied Pro-Ject Connect IT

5P – E cable to connect the turntable to the amplifier. You can substitute the interconnect cables supplied

with higher quality cables such as the Pro-Ject Connect IT Si interconnect cables for connection to the

amplifier if you wish. Use the Phono input (sometimes labelled gram, disc or RIAA) on your amplifier.

Make sure that the phono input offers correct matching and amplification for the type of cartridge used.

Line inputs (like CD, Tuner, Tape or Video) are not suitable.

Take care about connecting the left and right channel correctly. The

RED, the LEFT CHANNEL BLACK or WHITE. Check the manual of your amplifier for relevant information.

If your amplifier does not have an input suitable for phono cartridges, a separate phono amplifier stage

for MM or MC cartridges is required. It has to be connected between record player and a free line level

input of the amplifier.

For detailed product information regarding Pro-Ject Audio Systems interconnect cables and phono

amplifiers please visit our website:

A universal power supply with 3 exchangeable sockets adapters suitable for all countries is supplied.

Select the correct adapter for your country and insert the adapter to the exchangeable part of the power

supply.

Connect the low voltage plug from the power supply to the socket (19) on the rear of the record

player before connecting the power supply to the mains.

Fit the lid (dust cover 15) carefully over the hinge prongs and adjust the screws (17) until the lid stays

open where you want it to without being too stiff to open or close.

Press the main power button (20) to start the turntable.

www.project-audio.com

RIGHT CHANNEL

is usually marked

Table of Contents