Getting To Know The Ds2-A • Camera Installation And Balance - Ikan Beholder DS2-A Instruction Manual

Camera Installation and Balance
WARNING
Before installing the camera and adjusting the balance, remove the camera lens cover, attach the lens hood,
and insert a memory card and camera batteries, as well as any other accessories. The camera should be fully
ready to shoot.
STEP 1
Mount the camera quick release
• Remove the quick release plate from the gimbal.
• Attach the quick release plate to the camera (Fig. 4). Be careful not to twist it too tight at this point.
• Make sure the quick release plate direction is facing forward toward the lens.
Fig. 4. The camera is attached to the quick release plate
8
2017 Beholder ® All Right Reserved
▲