Advertisement
Getting Started
Before initial use, have a 12-20V pro battery fully charged for the receiver and motor power. The
hand control has an internal battery that lasts up to 10 hours. However, with the Lemo to USB
cable you may continue to shoot with no down time. You may also charge and power the hand
control with the P-Tap Cable.
There are multiple modes of operation for PD Movie Remote Air units. Upon startup and
calibration, the lens motor will operate in Standard mode. To change to Ramp mode, press the
Nerve button seven times, and the light will flash yellow
to indicate a mode change. In Ramp mode the speed
of the motor is slower, and it will ramp or "feather" the
ends of the motor movement. To return to Standard
mode, press the Nerve button seven times. The
indicator light will blink when the mode has switched.
The PD1 and PD2 motors are equipped with a .8
gear. The kits for both PD1 and PD2 are able to adapt
to multiple gears which are available as an optional
accessory. Three additional gears are included with the
PD-GEAR-KIT (.4, .5, and .6) and three hex screws,
which can be installed onto the existing .8 gear (see
picture at right).
Receiver Buttons & Operation
BUTTON / CONNECTION
ON / OFF CHANNEL
ANTENNA
MOTOR
REMOTE
12-20V
INSTRUCTION/FUNCTION
Hold for 2 seconds until display shows up.
Quick Press to change channel
Antenna Connection
Motor Connector
Optional Wired Controller
12–20V D-TAP Power Cable
Advertisement
