VTech IS8128 User Manual page 9

practical, you will be notified as soon as possible. You
will be given the opportunity to correct the problem
and the telephone service provider is required to
inform you of your right to file a complaint with the
FCC. Your telephone service provider may make
changes in its facilities, equipment, operation, or
procedures that could affect the proper functioning
of this product. The telephone service provider is
required to notify you if such changes are planned.
If this product is equipped with a corded or cordless
handset, it is hearing aid compatible.
If this product has memory dialing locations, you may
choose to store emergency telephone numbers (e.g.,
police, fire, medical) in these locations. If you do store
or test emergency numbers, please:
Remain on the line and briefly explain the reason for
the call before hanging up.
Perform such activities in off-peak hours, such as early
morning or late evening.
Industry Canada
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of
the device.
Privacy of communications may not be ensured when
using this telephone.
The term ''IC:'' before the certification/registration
number only signifies that the Industry Canada
technical specifications were met.
The Ringer Equivalence Number (REN) for this terminal
equipment is 0.1. The REN indicates the maximum
number of devices allowed to be connected to a
telephone interface. The termination on an interface
may consist of any combination of devices subject
only to the requirement that the sum of the RENs of all
the devices not exceed five.
This product meets the applicable Innovation, Science
and Economic Development Canada technical
specifications.
California Energy
charging testing instructions
This telephone is set up to comply with the energy-
conserving standards right out of the box. These
instructions are intended for California Energy
Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all
telephone functions, except battery charging, will be
disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the
power outlet. Make sure all handsets are plugged
with charged batteries before proceeding.
2. While you press and hold FIND HS, plug the
telephone base power adapter back to the power
outlet.
3. After about 20 seconds, when the telephone base
shows Registering... Please wait, keep pressing
FIND HS until the telephone base shows Deregister
all devices? Release FIND HS and then press it again
within two seconds. You hear a confirmation tone.
All handsets display To register HS... and ...see
manual. Allow up to one minute for the process to
complete.
NOTE
• When the phone fails to enter this mode, repeat
Step 1 through Step 3 above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from
the power outlet, then plug it back in. Then the
telephone base is powered up as normal.
2. Register your handsets back to the telephone base.
Refer to Add and register
Commission battery
handset.