Table of Contents
Advertisement
2 Installation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is
power-off during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid the damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the
bracket.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance
by yourself.
2.1 Ceiling Mounting of Type I and Type II Camera
Before you start:
Both wall mounting and ceiling mounting are suitable
for the dome camera. Ceiling mounting will be taken as
an example in this section. And you can take steps of
ceiling mounting as a reference for wall mounting.
Steps:
1. Paste the drill template to the celling.
2. Drill screw holes and the cable hole (optional) on
the ceiling according to the supplied drill template.
Note:
Drill the cable hole (hole A) when adopting the
ceiling outlet to route the cable.
3. Loosen the screws on the bubble of the dome
camera to remove the bubble.
Figure 2-2 Remove the Bubble and the Black Liner
4. Attach the back box of camera to the ceiling and
secure them with supplied screws.
Figure 2-1 The Drill Template
Advertisement
Table of Contents
