Table of Contents
Advertisement
Steps:
1. Drill 4 screw holes in the wall according to the holes
of the mount.
2. Attach the mount to the wall by aligning the 4 screw
holes of the mount with expansion screws on the
wall.
3. Secure the mount with 4 hex nuts and washers.
4. Refer to step 3 of 2.3 Ceiling Mounting of Type I
Type II Camera
5. Attach the back box of the dome camera to the wall
mount, and secure them with supplied screws.
Figure 2-8 Attach the Back Box to the Mount
6. Route the cables through the mount.
steps 6 to 9 of the
Repeat
Type I
and Type II Camera
Figure 2-7 Install Wall Mount
to remove dome camera's bubble.
Ceiling Mounting of
2.1
to complete the installation.
and
Advertisement
Table of Contents
