Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.10
Installing the lower triple clamp
x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the upper steering head seal
–
Slide on protective ring
401540-10
–
Position the upper triple clamp with the steering.
–
Mount screw
M00040-10
(SX‑F EU)
–
Position the fork legs.
Bleeder screws
M00019-11
(SX‑F US, XC‑F US)
–
Position the fork legs.
Bleeder screws
M00080-10
–
Fully tighten screws
Guideline
Screw, bottom triple clamp
M00034-10
p. 97)
and O-ring
but do not tighten yet.
are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
are positioned toward the front.
Info
The rebound damping is located in the right fork leg (red adjusting
screw). The compression damping is located in the left fork leg (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
.
is correctly positioned.
.
M8
12 Nm (8.9 lbf ft)
38
Advertisement
Table of Contents
