Installing The Air Filter Box Lid; Removing The Air Filter; Cleaning The Air Filter And Air Filter Box - KTM 250 SX-F EU 2015 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.23

Installing the air filter box lid

11.24

Removing the air filter

Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never operate the vehicle without an air filter as dust and dirt will enter the engine and lead to increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
11.25

Cleaning the air filter and air filter box

Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Do not clean the air filter with fuel or petroleum since these substances attack the foam.
–
Insert the air filter box lid into rear area
M00042-10
Condition
The air filter box lid is secured.
–
Mount and tighten screws
Guideline
Screw, air filter box lid
EJOT PT screw (0017060204)
M00041-10
x
Preparatory work
–
Remove the air filter box lid. (
Main work
–
Detach air filter holder
filter with the air filter support.
–
Remove the air filter from the air filter support.
B01426-10
x
Preparatory work
–
Remove the air filter box lid. (
–
Remove the air filter.

and clip it into front area

.
EJOT PT
K60x20-Z
p. 44)

at the bottom and swing it to one side. Remove the air
p. 44)
( p. 45)
x

.
® 3 Nm (2.2 lbf ft)
45