Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.46
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
x
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
M00050-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
Mount bleeding syringe
–
On the clutch slave cylinder, only release bleeder screw
ing is possible.
Info
M00051-10
Wash off overflowing or spilled brake fluid immediately with water.
Avoid contact between brake fluid and painted parts. Brake fluid attacks
paint.
Use only clean brake fluid from a sealed container.
–
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Tighten the bleeder screw and remove the bleeding syringe with the hose.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
C00445-10
.
with membrane
.
with the appropriate hydraulic fluid.
p. 95)
on bleeder screw
with a suitable hose piece.
to the point where fill-
of the master
4 mm (0.16 in)
56
Advertisement
Table of Contents
