PROAIM KITE-22-ULTIMATE Assembly Manual page 9

Pan Tilt Head Setup

Attach the pan tilt back into the head
platform mounted on the end of the jib and
secure with the provided knob.

Attach & secure your camera on the camera
platform of Head with the help of provided
chuck nut.

Install your cable starting at the camera end
making sure to leave enough slack for full pan
& tilt movements. Install and hookup the pan
& tilt joystick box on Jib Frame.
Cables & Control Box Setup

Install the 12 volt DC power (4 pin XLR) in
rear of joystick box.
NOTE: Any 12 volt battery may operate the PROAIM GOLD PAN TILT HEAD as long as the connector mates
and is #1 pin Negative and #4 pin Positive.
HEAD CABLES
Install your cable starting at the camera end;
leaving enough cable slack for the camera for
full pan & tilt movement, you may need to add
Velcro to loop the cable around the jib arm.
9