PROAIM KITE-22-ULTIMATE Assembly Manual page 7


Insert the bolts with washers and tighten
properly with the help of Wrench.
NOTE: This is the Pan Friction Knob. Never pan the Jib with this knob tightened. If this knob turns while
panning, it is too tight. Only tighten while parking the jib!

Insert the provided washer & knob to secure
the jib properly.
Jib Sections Setup

Insert rear tube section (section 1) into the
hub assembly, slide section 2 into section 1
and align holes of the Section 1 and section 2
with the central hole of hub assembly.

Already attached 1st and 2nd jib sections,
insert it into the hub then insert the long bolt
and nut to Secure the sections properly.
NOTE: We have provided double locking precautions on Jib, Knob is first and primary, pin is secondary
locking, so first lock the knob to avoid slipping of sections.

After alignment of holes (Jib arms) insert
shank lock pin & tighten it from another side
with shank threaded cap.
7
2
1