Manually Refreshing The Remote Emergency List; Receiving Remote Emergency; Sending An Emergency Alarm - Motorola APX 6000 User Manual

68012001079-JW
Chapter 7 : Advanced Features
If your radio receives acknowledgment, your radio displays a positive notification.
If your radio does not receive acknowledgment from the target radio, your radio displays a negative
notification.
7.11.5.3

Manually Refreshing the Remote Emergency List

Procedure:
1 Press the programmed Remote Emergency button.
2 To refresh the remote emergency list, press Rfsh.
Your radio displays List refreshed followed by the updated remote emergency list..
7.11.5.4

Receiving Remote Emergency

The remote emergency will only be launched if your radio has the emergency enabled. The receiving
radio displays Emergency.
Procedure:
To exit the emergency operation, press and hold the programmed Emergency button.
7.11.6

Sending an Emergency Alarm

When and where to use: This feature allows you to send a data transmission, which identifies the
radio sending the emergency, to the dispatcher.
NOTE: The default timer of Emergency button press to activate Emergency is 50 milliseconds.
This timer is programmable from 50–6200 milliseconds by a qualified technician.
Procedure:
Press the preprogrammed Emergency button.
One of the following scenarios occurs:
• The display shows Emergency on the current zone and channel. You hear a short medium-
pitched tone and the LED blinks red momentarily.
• The radio sounds a short low-pitched tone to indicate that the selected channel does not
support emergency and rejects to launch emergency mode.
When you receive the dispatcher's acknowledgment, the display shows Ack received. Four tones
sound, the alarm ends, and the radio exits the Emergency Alarm mode.
If no acknowledgment is received, the display shows No acknowledge. The alarm ends when the
timer expires and the radio exits the Emergency Alarm mode.
74