Table of Contents
Advertisement
Cleaning and Sanitizing
Cleaning: User Interface and Exterior Cabinet
1 . Press and release maintenance/clean switch so that only "FRESH FILTERED ICE AND WATER" displays
in the user interface to enter Cleaning Mode (and disable dispensing) .
2 . Plastic parts, including the user interface, can be cleaned with non-abrasive cleaners like Windex or
Fantastic . Clean stainless steel panels with stainless steel cleaner .
3 . Press and release maintenance/clean switch to put unit back into service .
Service –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
LED Indicator Description
The LED Indicator is located behind the front panel .
Fig . 17
LED Name
LED Color
Clean
Green
UV
N/A
Filter
Red
Drip tray
Red
Water leak
Red
High amps
Red
Service
Red
Maintenance
Yellow
Low water
Yellow
Time delay
Yellow
Sleep cycle
Green
Making ice
Green
Low bin
Green
Power on
Green
14
Dispenser and Icemaker 7CI100A/7FS100A
––––––––––––––––––––––––––––––––––––––
(continued)
The dispenser is in Cleaning Mode . Dispenser is disabled to allow for cleaning of front panel .
See
Maintenance/Cleaning Mode on page
Not used .
Six-month time has expired .
Drip tray full .
Internal leak in dispenser .
Auger gearmotor has exceeded 0 .55 amps .
8000 hour bushing check (call Follett technical service group at (877) 612-5086 or
+1 (610) 252-7301) .
Enter Maintenance Mode by pressing and holding maintenance/clean switch for 5 seconds .
Unit will not make or dispense ice .
Insufficient water supply to machine or no low bin LED upon startup .
Ice production will not resume for at least 15 minutes after a full bin is achieved and a
minimum amount of dispense activity has elapsed .
After a full bin and 10 minutes of non-use, the unit goes into standby and will not produce ice
until either 12 hours has elapsed or ice or water has dispensed .
Gearmotor, compressor, and fan motor energized .
Bin switch closed calling for ice .
Power supplied to unit .
Description
11. .
Advertisement
Table of Contents
