Electrical Specifications; Input Points - Delta DVP-10PM Instruction Sheet

 Electrical Specifications
Power supply voltage 100 ~ 240 VAC (-15 to 10%), 50/60 Hz  5%
Fuse capacity
Power consumption
DC24V current output 500 mA
Power protection
Withstand voltage
Insulation impedance > 5 MΩ (all I/O point-to-ground 500 VDC)
Noise immunity
Earth
Operation/storage
Vibration/shock
immunity
Weight (g)
 Input Points
Spec.
Items
Input wiring type
Input indicator
Input voltage (±10%)
Max. input current
Input point
configuration
OffOn
Active level
OnOff
Response time/noise
immunity
Unit: mm
2 A/250 VAC
60 VA
24 VDC, output short-circuited
1,500 VAC (Primary-secondary); 1,500 VAC (Primary-PE); 500 VAC
(Secondary-PE)
ESD: 8 kV Air Discharge, EFT: Power Line: 2 kV, Digital I/O: 1 kV,
Analog & Communication I/O: 250 V
The diameter of grounding wire shall not be less than that of the L, N
terminal of the power. (When many PLCs are used at the same time,
make sure every PLC is properly grounded.)
Operation: 0 to 55°C (temperature), 50 to 95% (humidity), pollution
degree 2
Storage: -25 to 70°C (temperature), 5 to 95% (humidity)
International standards: IEC61131-2, IEC 68-2-6 (TEST Fc) /
IEC61131-2 & IEC 68-2-27 (TEST Ea)
612
Two differential inputs
Independent wiring
LED display; light on = ON, light off = OFF
5 to 24 VDC
15 mA
X10+, X10-, X11+, X11-
X12-, X13+, X13-
24 VDC single common port input
200 kHz
Change wiring from S/S to SINK
#2
, X12+,
#3
20 μs
30 μs
0.5 μs
- 2 -
[ Figure 3 ]
or SOURCE
24 VDC
15 mA
#1
X0 to X7