Disassembly Instructions - Mitsubishi Electric SVZ-KP18NA Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
SUZ-KA09NA
OPERATING PROCEDURE
1. Removing the cabinet
(1) Remove the screw fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Remove the screws fixing the conduit cover.
(4) Remove the conduit cover.
(5) Disconnect the power supply wire and indoor/outdoor
connecting wire.
(6) Remove the screws fixing the top panel.
(7) Remove the top panel.
(8) Remove the screws fixing the cabinet.
(9) Remove the cabinet.
(10) Remove the screws fixing the back panel.
(11) Remove the back panel.
Photo 2
Conduit cover
TCH022
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
SUZ-KA12NA
Screw of the
conduit cover
Conduit plate
(2) The terminal with this connector has the
locking mechanism.
Connector
SUZ-KA15NA
NOTE: Turn OFF power supply before disassembling.
Photo 1
Screws
of the top
panel
Screws of
the cabinet
37
Hold the sleeve, and
pull out the terminal
slowly.
PHOTOS
Screw of the
Screws of
cabinet
the top panel
Service
panel
Back
panel
Screw of
the service
panel
Hooks