Mitsubishi Electric SVZ-KP18NA Service Manual page 36

[Operating Procedure]
Check the function selection settings.
Changing the function selection settings for each mode will change its relevant mode function. Perform steps 2 through 7 to check all the function selection settings,
and write down the current settings in the Check column of the function selection <Table 1> in the chapter 11-1, and then change the settings as necessary.
For the initial settings, refer to the <Table 1> in the chapter 11-1. The following is the procedure to operate the remote controller internal sensor.
Turn off the remote controller.
Hold down 2 buttons simultaneously for 2 seconds: the A
and B buttons to set the modes 01 through 14, and the J
and B buttons to set the modes 15 through 28.
FUNCTION
The " " will flash for a while and show "--" as below.
display section
FUNCTION
If the and temperature displays flash "88" for 2 seconds and stop flashing, this seems to be an error. Check for noise source or interference around the
transmission path.
Note: If the operation is made incorrectly before completion, finish operation by going to the step 0 and restart from the step 2.
Set the indoor unit No.
Press the D button to flash "--" in the unit No. display .
Unit number
display section
Confirm the address and unit No.
Press the E
button to confirm the address and unit No.
Mode number
display section
If the temperature display flashes "88", this indicates that the selected address
does not exist in the system. Or, if the unit No. shows "F" and the address flashes,
this indicates that the selected unit No. does not exist. In this case, set the correct
address and unit No. at the steps 2 through 3.
Select the mode number.
Press the [ TEMP] buttons (
number.
(Only vaild mode numbers can be selected.)
Select the setting No. in the selected mode.
MENU
Press the G button to flash the applying setting
No. Check the current setting No. here.
Setting number display section
Confirm the settings made at the steps 3 through 7.
Press the E
button to flash the mode No. and setting No.,
and to start registration.
If the mode No. or setting No. shows "---" and the temperature shows "
transmission path.
Exit the Function Selection screen.
Hold down 2 buttons simultaneously for 2 seconds or more: the A
TEST
B buttons for the modes 01 through 14, and the J
buttons for the modes 15 through 28.
TCH022
--".
and ) to select the desired mode
", this seems to be a transmission error. Check for noise source or interference around the
and B
Set the outdoor address.
Press the [ buttons (
address. The address changes from "00" to "15".
Press the buttons(
Select the unit No. to which the function selection applies.
To set the modes 01 through 06 or 15 through 22, select "00".
select "01" or "02".
When the address and unit number are confirmed by pressing the
MODE button, the corresponding indoor unit will start fan operation. This
helps you find the location of the indoor unit for which you want to perform function
selection.
Indoor unit
Confirm
Mode number
display section
Press the F
The mode No. and setting No. stop flashing to confirm the settings.
3 through 8.
88".
and
TEST
36
and ) to select the desired
and ) ) to indicate the indoor unit
Outdoor
unit
Main
Fan mode
Mode number 02 = Indoor temperature detection
and to select the desired setting No.