HP 53181A Programming Manual page 46

Commands Summary
HP 53181A Command Summary
:CALCulate2 (Cont.)
:LIMit (Cont.)
:FCOunt
:LOWer?
:UPPer?
[:TOTal]?
:LOWer
[:DATA] <numeric_value> [HZ | S]
:STATe <Boolean>
:UPPer
[:DATA] <numeric_value> [HZ | S]
:PCOunt
[:TOTal]?
:CALCulate3
:AVERage
:ALL?
:CLEar
:COUNt <numeric_value>
:CURRent?
[:STATe] <Boolean>
:TYPE MAXimum | MINimum |
SDEViation | SCALar or
MEAN
:DATA?
:FEED "[:]CALCulate[1]"
Table 2-2. HP 53181A SCPI Command Summary (Continued)
Keyword/Syntax Parameter Form
2-22
Std Subtree. An abbreviation for Fail COunt.
New Query only. Returns the number of limit test failures at
the lower limit.
New Query only. Returns the number of limit test failures at
the upper limit.
New Query only. Returns the total number of
measurements that failed the limit test.
Std Subtree.
Std Sets lower limit used in limit testing.
Std Sets the limit test enable. Note that this setting must
be enabled for any of the other :CALC2 settings can
be used.
Std Subtree.
Std Sets upper limit used in limit testing.
New Subtree. An abbreviation for Pass COunt.
New Query only. Returns the total number of
measurements that passed the limit test.
Std Subsystem. Performs post-aquisition statistics
computation and data transfer.
Std Subtree. Collects together the commands associated
with the Statistics capabilities.
New Returns all four Statistics reults (i.e., mean, standard
deviation, maximum, and minimum).
Std Event; no query. Clears the statistics results and
statistics count.
Std Selects number of measurements to combine for
statistics.
New Query only. Returns the current number of data values
collected, thus far.
Std Enables/disables statistics post-processing. Note that
this setting must be enabled for any of the other
:CALC3 settings to be used.
Std Selects which statistic will be in :CALC3:DATA?,and
on the front-panel display.
Std Query only. Returns statistic result specified by
:CALC3:AVER:TYPE.
Std Sets the data flow to be fed into the CALCulate3 block.
Std/ Comments
New