HP 53181A Programming Manual page 303

Continued from front matter . . .
Warranty (contd)
For warranty service or repair,
this product must be returned to a
service facility designated by HP.
Buyer shall prepay shipping
charges to HP and HP shall pay
shipping charges to return the
product to Buyer. However,
Buyer shall pay all shipping
charges, duties, and taxes for
products returned to HP from
another country.
HP warrants that its software and
firmware designed by HP for use
with an instrument will execute
its programming instructions
when properly installed on that
instrument. HP does not warrant
that the operation of the
instrument, or software, or
firmware will be uninterrupted or
error free.
Limitation of Warranty
The foregoing warranty shall not
apply to defects resulting from
improper or inadequate
maintenance by Buyer, Buyer-
supplied software or interfacing,
unauthorized modification or
misuse, operation outside the
environmental specifications for
the product, or improper site
preparation or maintenance.
NO OTHER WARRANTY IS
EXPRESSED OR IMPLIED. HP
SPECIFICALLY DISCLAIMS
THAT IMPLIED
WARRANTIES OR
MERCHANTABILITY AND
FITNESS FOR A
PARTICULAR PURPOSE.
Exclusive Remedies
THE REMEDIES PROVIDED
HEREIN ARE BUYER'S SOLE
AND EXCLUSIVE
REMEDIES. HP SHALL NOT
BE LIABLE FOR ANY
DIRECT, INDIRECT,
SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL
DAMAGES, WHETHER
BASED ON CONTRACT,
TORT, OR ANY OTHER
LEGAL THEORY.
Assistance
Product maintenance agreements
and other customer assistance
agreements are available for
Hewlett-Packard products.
For any assistance, contact your
nearest Hewlett-Packard Sales
and Service Office.
Safety Considerations
(contd)
WARNING
ANY INTERRUPTION OF
THE PROTECTIVE
GROUNDING CONDUCTOR
(INSIDE OR OUTSIDE THE
INSTRUMENT) OR
DISCONNECTING THE
PROTECTIVE EARTH
TERMINAL WILL CAUSE
A POTENTIAL SHOCK
HAZARD THAT COULD
RESULT IN PERSONAL
INJURY. (GROUNDING ONE
CONDUCTOR OF A TWO
CONDUCTOR OUT-LET IS
NOT SUFFICIENT
PROTECTION.)
Whenever it is likely that the
protection has been impaired, the
instrument must be made
inoperative and be secured
against any unintended operation.
If this instrument is to be
energized via an autotransformer
(for voltage reduction) make sure
the common terminal is
connected to the earthed pole
terminal (neutral) of the power
source.
Instructions for adjustments
while covers are removed and for
servicing are for use by service-
trained personnel only. To avoid
dangerous electric shock, do not
perform such adjustments or
servicing unless qualified to do
so.
For continued protection against
fire, replace the line fuse(s) only
with 250V fuse(s) of the same
current rating and type (for
example, normal blow, time
delay). Do not use repaired fuses
or short circuited fuseholders.
Acoustic Noise Emissions
LpA<47 dB at operator position,
at normal operation, tested per
ISO 7779. All data are the results
from type test.
GERAeUSCHEMISSION
LpA<47 dB am Arbeits platz,
normaler Betrieb, geprueft nach
DIN 45635 Teil 19. DieAnbagen
beruhen auf Ergebnissen von
Typpruefungen.