HP 53181A Programming Manual page 43

Commands Summary
HP 53181A Command Summary
Table 2-1. IEEE 488.2 Common Commands (Continued)
Mnemonic Command Name
*OPT? Option Identification Query
*PMC Purge Macro Command
*RCL <NRf> Recall
*RST Reset
*SAV <NRf> Save
*SRE <NRf> Service Request Enable
*SRE? Service Request Enable Query
*STB? Status Byte Query
*TRG Trigger
*TST? Self-Test Query
*WAI Wait-to-Continue
Note: Pending operations include measurements in progress.
Function
Identifies the options installed in the Counter.
Deletes all macros previously defined using the
*DMC command.
Restores the state of the Counter from a copy stored
in local non-volatile memory (0 through 20 are valid
memory registers).
Resets the Counter to a known state.
Stores the current state of the Counter in local non-
volatile memory (1 through 20 are valid memory
registers).
Set the Service Request Enable register.
Queries the Service Request Enable register.
Queries the Status Byte and Master Summary Status
bit.
This trigger command is the device-specific analog
of the IEEE 488.1 defined GET. It initiates
measurement, unless *DDT was used to redefine
device trigger.
Executes an internal self-test and reports the results.
Makes Counter wait until all pending operations
(see Note) are completed before executing
commands following *WAI command.
2-19