HP 53181A Programming Manual page 118

Programming Your Counter for Remote Operation
Programming Examples
Using QuickBASIC
The QuickBASIC examples assume you have an HP 82335A
HP-IB Interface card inside your IBM PC or compatible.
Using Turbo C
The Turbo C examples assume you have an HP 82335A
HP-IB Interface card inside your IBM PC or compatible.
List of the Programming Examples
The following examples are provided:
All programming examples use the ASCII format to transfer data from the Counter
NOTE
to the computer. The ASCII format is the default format when *RST is used.
3-60
1. Easiest Way to Make a Measurement (HP BASIC only)
2. To Make a Frequency Measurement
3. To Perform Limit Testing (HP BASIC and QuickBASIC only)
4. To Measure the Statistics of 50 Measurements (HP BASIC and
QuickBASIC only)
5. To Use Limits to Filter Data Before Measuring Statistics.
6. To Read and Store Calibration Data — this program is useful if
you plan to calibrate your HP 53181A and want to
be able to return to the original calibration at a later date.
(HP BASIC and QuickBASIC only)
7. To Optimize Throughput; that is, to set up the Counter to transfer
data at the fastest possible rate.
8. To Use Macros