Printek PrintMaster 862 Operator's Manual page 55

printer, enter Setup and make them before removing the Setup Module. Any changes made will
automatically be stored both in the printer's internal memory and the Setup Module.
You may now power off the printer and remove the Setup Module. Remember to reconnect the serial cable
if one was attached.
Now perform the installation procedure on each of the printers that are to be configured the same as the
first. In step 9 be sure to press the LOAD button to copy data to the printer. After the Setup Module is
removed, remember to reconnect the serial cable if one was attached.
Note: Setup modules for Printek FormsMaster 8000 Series printers and PrintMaster 860 Series
printers are not interchangeable. Data backup will not take place if the modules are used on the
wrong printer.
U S I N G T H E O P T I O N A L S E T U P M O D U L E
49