Rangemaster Classic Deluxe 110 Ceramic User Manual & Installation & Service Instructions page 29

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
13. To Adjust an Oven Door Catch Keep
Open the oven door, and slacken off the locknut at the
base of the keep:
Screw in or out as required until the required fit is
obtained. Retighten the locking nut.
14. To Replace an Oven Door Seal
Open the oven door. The seal has small hooks which
hold it in place by locating into holes in the rear door
face on the main oven and oven front face on tall oven.
At the corner, pull theseal diagonally away from the door
centre until the hook is released. Proceed to the next
hook and release it in a similar way, and so on.
When fitting the new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes
of the door, and proceed around the door, snapping in
each hook in turn.You can use force if the hooks are stiff,
as the old seal will be discarded.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the four screws and washers are
fully tightened.
15. To Remove Grill Door
Remove the control panel (see section 1). Remove the
left hand side panel (see section 2). Remove the centre
cover strip (5 screws, 2 top, 2 bottom, 1 in middle).
Remove the two countersunk screws (1 each side)
securing the grill hinge arms to the front of the grill
chamber.
NOTE: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket is
fitted between the hinge arm and the front of the grill
chamber.
16. To Remove an Oven Element Thermal Cut-Out
Disconnect from electricity supply.
Pull the cooker forward to gain access to the cover
box. Undo the cover screws and lift clear. The cutout
is located on the earth plate beside the oven element
connections. Disconnect the cutout wiring. Undo the
fixings that secure the cutout to the earth plate and
remove. Fit the replacement control and re-assemble in
reverse order.
17. To Remove Oven Inner Back
Disconnect from electricity supply.
Open door and remove shelves. Remove screws and
washers, four on the left over as shown in the diagram
and two on the right oven and securing the inner back of
the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the screws and washers are fully
tightened.
18. To Remove the Fan Oven Element
Disconnect from electricity supply.
Remove the oven inner back - see section 17.
Remove the two screws from the top of the element
and the one from the bottom of the element inside
the oven. Lift the element out carefully, disconnecting
the terminals connected to the element (noting their
positions). If it is not possible to disconnect the leads in
this way, pull the cooker forward to gain access to the
rear, remove the screws securing the electric cover to
the back sheet, remove the cover and disconnect the
terminals from the rear.
Fit the new element and reassemble in reverse order.
Check the operation of the oven.
29