Rangemaster Classic Deluxe 110 Ceramic User Manual & Installation & Service Instructions page 28

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Reassemble in reverse order. When replacing the leads,
refer to the wiring diagram in this manual. Check the
operation of the timer.
7. To Replace a Thermostat
Disconnect from the electricity supply.
Remove control panel (see section 1) and lift hob (see
section 3). Open the oven door. Remove the oven
furniture and slide out the oven roof liner if fitted.
For the RH oven, remove the thermostat phial cover (two
screws). Unclip the thermostat phial from the clips in the
oven back.
For the LH oven, pull cooker forward to gain access to
the cover box at the rear of the cooker. Remove the four
screws securing the cover and lift clear.
Feed the thermostat capillary out of the oven.
Disconnect the wiring from the thermostat. Remove
two screws holding thermostat to mounting panel. Fit
new thermostat and reassemble in reverse order. Ensure
that the phial is clipped to the oven back with the phial
centrally positioned between the clips.
Check the operation of the thermostat.
8. To Replace the Grill Controller
Disconnect from electricity supply.
Remove the control panel and lift up the hob (see
sections 1 and 3). Disconnect the wiring from the
controller. Remove the two screws holding the controller
to the mounting panel. Fit the new controller and
reassemble in reverse order. Check for correct operation.
9. To Replace an Oven Door
Open the oven door. Support the door and remove the
two screws securing the upper hinge and gasket to the
cooker front. Remove the door from the lower hinge by
lifting slightly and moving outwards
The door is heavy, so take care.
Reassemble in reverse order.
10. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted
to alter the angle of the door. Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
ArtNo.320-0006 Oven door hinge adjustment 1
Centre line of hinge pin
Oven door omitted for clarity
11. To Replace an Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove the door handle from the panel by unscrewing
the two retaining nuts. Fit the door handle to the new
panel.
Fit the panel to the door. Reassemble in reverse order.
12. To Change the Oven Door Latch
Remove the outer door panel - see section 13. Remove
screws 'B' that hold the latch assembly to the inner door
panel. Fit the new catch and reassemble in reverse order.
Verify the door operation.
.
28