Table of Contents
Advertisement
5. Remove the
wireless
card.
6. Remove the speakers.
7. Remove the fan.
8. Remove the
display
assembly.
9. Remove the
I/O
board.
10. Remove the
system
board.
Procedure
1. Follow the procedure from step 1 to step 5 in
2. Open the latch and disconnect the fingerprint-reader cable from the power button with fingerprint-reader.
3. Lift the power button with fingerprint-reader, along with the power button cable, off the keyboard bracket.
4. Peel the tape and remove the power button with fingerprint-reader from the keyboard bracket.
Replacing the power button with fingerprint reader
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
NOTE:
Applicable only for computers that are shipped with fingerprint reader.
Procedure
1. Align the power button with fingerprint reader on the keyboard bracket and adhere the tape that secures the power button with
fingerprint reader on the keyboard bracket.
2. Place the power button with fingerprint reader on the keyboard bracket.
3. Connect the fingerprint-reader cable to power button with fingerprint reader and close the latch to secure the cable.
48
Removing and installing components
"Removing the
keyboard".
computer. After working inside your computer, follow the instructions in
After
Advertisement
Table of Contents
