Product Status Messages - Epson SureColor P6570 Series User Manual

Parent topic:

Product Status Messages

You can often diagnose problems with your product by checking the messages on the LCD screen.
LCD screen message
Change paper settings
Paper setting in the printer driver
is different from paper
information registered in the
printer. Change paper setting
from the application or the driver.
For details, see your
documentation.
TCP/IP configuration failed
The combination of the IP
address and the subnet mask is
invalid. See your documentation
for more details.
A printer part needs to be
replaced
Contact Epson Support. For
details, see your documentation.
XXXXXXXX
(maintenance request code)
Solving Problems
Condition/solution
To change paper information that was registered using Epson Media
Installer, load the paper and then use the control panel.
You can also use Epson Media Installer to change paper information
for paper that has not been loaded.
Depending on the version of Epson Media Installer you are using,
you may not be able to change the paper information.
Check the media settings on the driver to determine which media is
being used. To change the media, select Paper Setting > paper
source > Change Paper type > Paper Type, and select the media
that matches the driver setting.
You can also select Use Printer Settings when you select the
media, which will default to the paper that is set on the LCD screen.
Enter the correct values for the IP address and the default gateway.
Check with your network administrator if you do not know the correct
values.
A part used in the printer is nearing the end of its service life. Contact
Epson for support and provide them with the displayed maintenance
request code. The error persists until you replace the requested part.
If you continue to use the printer, a printer error will occur.
344