Product Status Messages - Epson WF-7110DTW User Manual

Product Status Messages

You can often diagnose problems with your product by checking the messages on its LCD screen.
Note: If the screen is dark, press the screen to wake the product from sleep mode.
LCD screen message
Paper Jam
Printer Error
Maintenance box is nearing end of its The maintenance box is near the end of its service life.
service life.
Maintenance box is at the end of its
service life. You need to replace it.
A printer's ink pad is nearing the end The ink pads are near the end of their service life and the
of its service life. Please contact
Epson Support.
A printer's ink pad is at the end of its
service life. Please contact Epson
Support.
Invalid IP address and subnet mask. There is a problem with the network connection to your product.
Recovery mode
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD, or lights on the control panel will advise you when these parts need replacing. If this happens
during the standard warranty of the product, the exchange of the product or replacement of the pads is
covered under the standard warranty. If the product is out of warranty, the pads can be replaced by any
Epson authorized service provider. The waste ink pads are not a user-replaceable part.
Condition/solution
If paper is jammed in the product, follow the instructions in this
guide to remove the jammed paper from the indicated area.
A serious error has occurred. Turn the product off and then back
on again. If the error continues, check for a paper jam. If there is
no paper jam, contact Epson for support.
You must replace the maintenance box to continue printing.
message will be displayed until the ink pad is replaced. Contact
Epson to replace ink pads before the end of their service life.
The ink pad is at the end of its service life. Turn off the product
and contact Epson for support.
An error has occurred during firmware updating. Connect your
product using a USB cable and try downloading the Firmware
Update from Epson's support website. If you still need help,
contact Epson for support.
133