Table of Contents
Advertisement
Product Status Messages
You can often diagnose problems with your product by checking the messages on the LCD screen.
LCD screen message
The maintenance box is
not recognized.
Cannot start cleaning
because the
maintenance box is full.
Replace it and try again.
Command Error
Check the printer driver
setting.
Recovery Mode
Maintenance Request
Replace Parts Soon/End
of Parts Service Life
(maintenance request
code)
Printer Error
Printer error. Turn the
power off and on again.
If the problem persists,
contact Epson Support.
(printer error code)
Parent topic:
Resetting Control Panel Defaults
If you have a problem with settings on the product control panel, you can reset them to their factory
defaults. You can choose which settings to reset or reset them all.
Condition/solution
Remove and reinsert the maintenance box. If the message persists, insert a
new maintenance box.
The maintenance box does not have enough capacity to store ink discharged
in print head cleaning. Do not perform head cleaning until you replace the
maintenance box with a new one. The used maintenance box may be
reinstalled after cleaning is completed.
Select Cancel to stop printing. Make sure that the printer driver you are using
supports your product.
The printer restarted in recovery mode because the firmware update failed.
Make sure the computer and printer are connected via USB and try updating
the firmware again.
A part used in the printer is nearing or at the end of its service life. Contact
Epson for support and provide them with the displayed maintenance request
code. The error persists until you replace the requested part.
Turn off the printer, disconnect the power cable from the outlet and from the
printer, and reconnect it. Turn on the printer again. If the message persists,
contact Epson for support and provide them with the displayed printer error
code.
Solving Problems
175
Advertisement
Table of Contents
