Table of Contents
Advertisement
4. Attach the Frame (3) to the Crossbar (2) with
two M8 x 70mm Bolts (27) and two M8 Locknuts
(34); do not fully tighten the Locknuts yet.
5. Insert the Backrest Support (14) into one of the
three sets of holes in the Uprights (1).
See the inset drawing. Rotate the Backrest
Support (14) so that the clip (C) is wrapped
around an Upright (1) as shown.
See steps 2–4. Tighten the M8 Locknuts
(34) and the M8 x 45mm Bolts (28) used in
these steps.
6. Using a small plastic bag to keep your fingers
clean, apply some of the included grease to an
M10 x 60mm Bolt (25).
Attach the Leg Lever (6) to the Front Leg (4) with
the M10 x 60mm Bolt (25) and an M10 Locknut
(31). Do not overtighten the Locknut; the Leg
Lever must pivot easily.
4
3
5
14
1
6
4
31
6
9
27
2
34
1
14
C
1
Grease
25
Advertisement
Table of Contents
