Table of Contents
Advertisement
7. Insert a Pad Tube (12) through the Leg Lever
(6). Then, slide a Foam Pad (13) onto each side
of the Pad Tube, and press a Pad Cap (5) into
each end of the Pad Tube.
Repeat this step with the other Pad Tube (12),
Foam Pads (13), and Pad Caps (5).
8. Orient the Backrest (8) as shown.
Next, orient the Backrest Tubes (7) so that the
indicated holes (D) are in the position shown.
Attach the Backrest Tubes (7) to the Backrest (8)
with four M6 x 40mm Screws (32) and four M6
Washers (22); do not tighten the Screws yet.
9. Apply grease to an M10 x 135mm Bolt (23).
Attach the Backrest Tubes (7) to the Frame (3)
with the M10 x 135mm Bolt (23), two M10
Washers (30), and an M10 Locknut (31). Do not
overtighten the Locknut; the Backrest Tubes
must pivot easily.
See step 8. Tighten the M6 x 40mm Screws (32).
7
5
13
6
5
13
8
8
D
9
31
30
7
3
10
12
13
12
13
5
7
22
32
22
32
30
23
Grease
5
Advertisement
Table of Contents
