Panasonic WX-CC412BP Operating Instructions Manual page 23

Setting the Center Module
w p Touch the [YES] button to start Wireless repeater ID
registration mode.
3
Connect the USB power adaptor to the
Wireless Repeater and confirm that [STATUS]
indicator lights red or blinks red.
Note
w p The [STATUS] indicator lights red if the ID registration
information for the Center Module is not in the
Wireless Repeater.
w p If ID registration information for the Center Module
remains in the Wireless Repeater, the indicator blinks
orange (or green) for about 3 seconds before starting
to blink red.
4
Press and hold the Wireless Repeater [ID REG]
button for 3 or more seconds.
w p The Wireless Repeater starts in ID registration
mode and the [STATUS] indicator blinks orange. The
Wireless Repeater searches for the Center Module in
the repeater ID registration mode.
w p The numbers of any registered Wireless Repeaters
are shown in the [Registered Wireless Repeaters]
field during registration. If ID registration succeeds,
the ID of the registered repeater is added.
w p If ID registration succeeds, the [STATUS] indicator on
the Wireless Repeater lights orange (or blinks orange
slowly) when registering to Lane A. It lights green (or
blinks green slowly) when registering to Lane B.
Note
w p You can continue to register until 2 Wireless Repeaters
are registered in the Center Module.
Touch the [Stop] button to exit the ID registration
mode.
w p To continue and register a 2nd Wireless Repeater,
perform steps 3 and 4 on the other Wireless Repeater.
When registration of the 2nd unit for a single Center Module
is successfully completed, the following pop-up confirmation
screen is displayed, and the repeater ID registration mode
on the Center Module is automatically exited.
Important
w p When registering multiple Wireless Repeaters, do the
ID registration procedure one at a time in order. ID
registration may not be successful if you try to do the
ID registration procedure for multiple units at the same
time.
w p Do not unplug the USB cable or USB power adaptor
from the Wireless Repeater during ID registration. ID
registration may not be completed successfully. If ID
registration does not go well, touch the [Stop] button
on the Center Module to exit the ID registration mode,
then try it again.
w p If ID registration fails, the ID of the Wireless Repeater
is not registered to the Center Module, and the
[STATUS] indicator on the Wireless Repeater lights red
or blinks red.
w p The IDs of up to 2 Wireless Repeater units can be
registered in each single Center Module.
L When WX-CC411BP is used, 2 can be registered in
w
1 lane.
L When WX-CC412BP is used, you can register 1
w
Wireless Repeater per lane or 2 in 1 lane.
23