Panasonic WX-CC412BP Operating Instructions Manual page 20

Setting the Center Module
Important
w p When registering the IDs of a multiple number of All-
In-One Headsets or Belt Packs, register the ID of each
unit in sequence. If an attempt is made to register the
IDs of multiple units at the same time, the IDs may not
be registered correctly.
w p During the ID registration process, do not turn off
the power of the All-In-One Headsets or Belt Packs
or remove their batteries. Otherwise, their IDs may
not be registered correctly. If the registration is not
proceeding smoothly, touch the [Stop] button on the
Center Module, exit ID registration mode, and then try
again.
w p When ID registration fails, a "BUU-UU-UU" warning
sounds in the All-In-One Headset or Belt Pack
concerned, and then the "Failed" voice prompt is
heard. If an ID registration has failed, the ID of the
All-In-One Headset or Belt Pack will not be registered
in the Center Module, and the power indicator of the
All-In-One Headset or Belt Pack concerned will blink
in red.
w p The IDs of up to 32 All-In-One Headsets or Belt Packs
can be registered in one Center Module. If an attempt
is made to register IDs for more than 32 units, the IDs
of the headsets not used for the longest time will be
automatically deleted, and then the IDs of the new
units will be registered.
w p It is not possible to register the ID of a Wireless
Repeater while ID registration mode of the All-In-One
Headsets or Belt Packs is active.
This function is used to cancel the ID registration of All-In-
One Headsets or Belt Packs.
1
Turn off the All-In-One Headset or Belt Pack to
be deleted.
2
On the Settings screen, touch the [Headsets]
button, and then the [ID Deletion] button.
w p All of the All-In-One Headsets or Belt Packs with
registered IDs are displayed in a list.
* If there is no All-In-One Headset or Belt Pack with
registered IDs, this screen is not displayed.
3
On the ID Deletion screen, touch the [Deletion]
button of the All-In-One Headset or Belt Pack
to be deleted.
w p The following confirmation pop-up screen is
displayed. To delete, touch the [YES] button. To
cancel deletion, touch the [NO] button.
Note
w p You can check your Headset number by turning it on
and listening to the voice prompt. When an All-In-One
Headset or Belt Pack is turned on, the following voice
prompts will be heard: "Hello", "Headset xx" (xx is the
ID number registered in the Center Module), "Lane x"
(x is the connected lane).
20
How to delete an ID