Table of Contents
Advertisement
TRENDnet User's Guide
5. Click Save Settings to Flash, then click OK
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Set DSCP (Differentiated Services Code Point) Class Mapping settings
QoS > DSCP
If you choose to use the DSCP tags in your Access Control policy configuration, each
DSCP value (0-63) that is relevant to your configuration needs to be mapped to one of
the four egress queues(Low, Medium, High, or Highest). The default queue for all DSCP
values is 0.To assign the queue mappings to the DSCP values, perform the following
procedure.
1. Log into your switch management page (see
on page 6).
2. Click on QoS and click on DSCP.
3. For each DSCP In value that is relevant to your configuration, select a queue (Low,
Medium, High, or Highest) in the Queue column. Select Enabled in the DSCP Mapping
drop-down list. Click Apply to save the settings.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management
page"
4. In the left hand panel, click on Save
5. Click Save Settings to Flash, then click OK
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Set the Scheduling Algorithm
QoS > Scheduling Algorithm
1. Log into your switch management page (see
on page 6).
2. Click on QoS and click on Scheduling Algorithm.
3. Review the settings. Click Apply to save the settings.
TPE-TG50ES
"Access your switch management
page"
33
Advertisement
Table of Contents
