Table of Contents
Advertisement
TRENDnet User's Guide
Set Egress Rate Limiting
Network > Bandwidth Control > Egress Rate Limiting
This section allows you to set the egress (transmit) rate for each switch port.
1. Log into your switch management page (see
on page 6).
2. Click on Network, click on Bandwidth Control, and click on Egress Rate Limiting.
3. Review the settings for each port. Click Apply to save the settings.
Bandwidth – Select the egress rate limit value from the drop down menu.
Note: Modifying settings in the row marked All, will apply the settings to all
ports.
4. In the left hand panel, click on Save
5. Click Save Settings to Flash, then click OK
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management
page"
Add, modify, and remove VLANs
Network > VLAN > Tagged VLAN
A VLAN is a group of ports that can be anywhere in the network, but communicate as
though they were in the same area.
VLANs can be easily organized to reflect department groups (such as R&D, Marketing),
usage groups (such as e-mail), or multicast groups (multimedia applications such as
video conferencing), and therefore help to simplify network management by allowing
users to move devices to a new VLAN without having to change any physical
connections.
1. Log into your switch management page (see
on page 6).
2. Click on Network, click on VLAN, and click on Tagged VLAN.
3. Review the settings.
VLAN ID – Enter the VLAN ID for the new VLAN.
VLAN Name – Enter the VLAN name.
Note: By default, the default VLAN VID 1 is set as the Management VLAN.
In the sections Static Tagged, Static Untagged, and Not Member, you can add the type
of VLAN ports to add to the new VLAN (Tagged or Untagged) and assign ports that are
not members (Forbidden) of the new VLAN.
TPE-TG50ES
"Access your switch management
page"
25
Advertisement
Table of Contents
