TRENDnet TPE-TG50ES User Manual page 7

5-port gigabit edgesmart poe+ switch

Table of Contents

TRENDnet User's Guide

6. Click System and then click IPv4 Setup.

7. Configure the switch IP address settings to be within your network subnet, then click

Apply.

Note: You may need to modify the static IP address settings of your computer's network

adapter to IP address settings within your subnet in order to regain access to the switch.

5. In the left hand panel, click on Save

6. Click Save Settings to Flash, then click OK.

Note: This step saves all configuration changes to the NV-RAM to ensure that if the

switch is rebooted or power cycled, the configuration changes will still be applied.

TPE-TG50ES

Table of Contents