Table of Contents
Advertisement
TRENDnet User's Guide
Configure port mirror settings
Network > Mirroring
Port mirroring allows you to monitor the ingress and egress traffic on a port by having
the traffic copied to another port where a computer or device can be set up to capture
the data for monitoring and troubleshooting purposes.
1. Log into your switch management page (see
on page 6).
2. Click on Network, and click on Mirroring.
3. Review the settings. Click Apply to save changes.
Mirroring Status – Click the drop-down and list and select one of the following
options:
o
Enable - This parameter activates the Port Mirroring feature and the
rest of the configuration parameters become active on the page.
o
Disable - This parameter de-activates the Port Mirroring feature and
the rest of the configuration parameters become inactive on the page.
Mirror Target Port – Click the drop-down and list and select the port to send
the copied ingress/egress packets/data. (e.g. Computer or device with packet
capture or data analysis program.)
Frame Type: Click the drop-down menu and select one of the following options
o
Ingress: This parameter allows configuration of the inbound traffic to
the selected port.
o
Egress: This parameter allows configuration of the outbound traffic to
the selected port.
o
Ingress/Egress: This parameter allows configuration of the inbound
and outbound traffic to the selected port.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management
page"
Check the port to monitor or copy inormation from. (Source)
To copy data received on a specific port, check the port number(s) under the Ingress
Port section or you could click All to copy data received on all ports.
To copy data transmitted on specific port, check the port number under the Egress Port
section or you could click All to copy data transmitted on all ports.
4. In the left hand panel, click on Save
5. Click Save Settings to Flash, then click OK
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-TG50ES
19
Advertisement
Table of Contents
