Dscp; Set Dscp (Differentiated Services Code Point) Class Mapping Settings - TRENDnet TEG-S80ES User Manual

TRENDnet User's Guide

DSCP

Set DSCP (Differentiated Services Code Point) Class Mapping settings

QoS > DSCP
If you choose to use the DSCP tags in your Access Control policy configuration, each
DSCP value (0-63) that is relevant to your configuration needs to be mapped to one of
the four egress queues(Low, Medium, High, or Highest). The default queue for all DSCP
values is Medium. To assign the queue mappings to the DSCP values, perform the
following procedure.
1. Log into your switch management page (see
on page 7).
2. Click on QoS and click on DSCP.
3. Select Enabled in the DSCP Mapping Status drop-down list to enable DSCP. For each
value that is relevant to your configuration, select a queue priority (Low, Medium,
High, or Highest) in the Priority column. Click Apply to save the settings. Click Reset to
Default at the bottom of the page to reset the priorities back to their default values.
NOTE: The configured settings are only applied to the switch's temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch's NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
1. From the menu on the left: click on Save, then click the blue button Save
Settings to Flash.
2. Click Continue to return to the Web Configuration of your switch.
TEG-S80ES
43