Table of Contents
Advertisement
TRENDnet User's Guide
Set Egress Rate Limiting
Network > Bandwidth Control > Egress Rate Limiting
This section allows you to set the egress (transmit) rate for each switch port.
1. Log into your switch management page (see
on page 7).
2. Click on Network, click on Bandwidth Control, and click on Egress Rate Limiting.
3. Review the settings for each port. Click Apply to save the settings.
Bandwidth – Select the bandwidth limit in bits per second from the dropdown
menu.
NOTE: The configured settings are only applied to the switch's temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch's NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management
page"
1. From the menu on the left: click on Save, then click the blue button Save
Settings to Flash.
2. Click Continue to return to the Web Configuration of your switch.
TEG-S50ES
31
Advertisement
Table of Contents
