Yealink SIP-T19P E2 Recovery Manual page 8

Recovery Mode on Yealink IP phones
3. Enter the desired values in the IP Address, Netmask, IP Gateway and HTTP Server fields
respectively.
Note
For CP920 IP phones, you need to press the volume key (
navigation key.
For SIP-T58A IP phones, you need to press
navigation key.
4.
Press to complete the recovery mode.
The IP phone will download and upgrade the firmware from the HTTP server. After upgrading, the IP
phone will initialize successfully and get ready for use.
The LCD screen prompts "Initializing...Please Wait" when upgrading successfully.
Note
You need to press
recovery mode since there is no
5.
If the IP phone fails to upgrade, the LCD screen will indicate the failure. The user can repeat the
recovery mode procedures to try again.
10. 2. 11.124
IP Address:
Netmask:
255.255.255. 0
IP Gateway:
10. 2. 11.254
HTTP Server:
http://10.2.11.10
1
Welcome
....
Initializing
Please Wait
(for SIP-T58A phones),
key.
or ) as the left or right
/ / as up/down/left/right
....
(for SIP-T3 IP phones) to complete the
8