Electronic Control Setup Instructions - Maytag MLG21PD Installation Instructions Manual

Washer Control
NOTE: After the washer/dryer has been installed and plugged
in, the display will show "0 MINUTES" on the washer and dryer
portions of the display. After the washer and dryer doors have
been opened and closed, the display will show the price for each
machine. On washer/dryers set for free cycles, the display sections
will flash "SELECT CYCLE. "
1. PD Models: Insert coins until "SELECT CYCLE" flashes on the
display portion of the washer or dryer that is to be run.
PN Models: Sent from the factory as Free Vend. If a debit card
reader is installed, then a debit card is required rather than
coins. Generation 1 or 2 debit card systems may be used;
but when the Generation 2 debit system is used, the controls
will automatically be set to Enhanced Debit mode (J. Ed). In
Enhanced Debit mode, the card balance will also display when
a debit card is inserted into the reader.
2. Door must be closed on the desired washer/dryer before cycle
selection is made.
3. Press the fabric setting button for the washer/dryer cycle
desired. After the cycle is started, the time will display and
count down.
4. If a cycle is interrupted by opening the door or power loss,
"RESELECT CYCLE" will flash in the display. To restart the
washer/dryer, close door and reselect desired cycle.
NOTE: When set for free vend operation an ongoing dryer cycle
will cancel if the door is opened.

ELECTRONIC CONTROL SETUP INSTRUCTIONS

Dryer Control
General Washer/Dryer User Information
SCROLLING "OUT OF ORDER" MESSAGE, FOLLOWED BY A
FAILURE OR DIAGNOSTIC CODE, SHOWING IN DISPLAY – This
condition indicates the washer/dryer is inoperative. Diagnostic
codes being displayed on the upper portion of the display pertain
to the dryer section, and diagnostic codes displayed on the lower
portion of the display apply to the washer section. Diagnostic
codes displayed on both the upper and lower portions of the
display pertain to the control system of both the washer and dryer.
"0 MINUTES" SHOWING IN DISPLAY – This indicates the cycle
is complete and the washer/dryer cannot be operated. Coins
dropped or debit inputs during this condition will be stored in
escrow but cannot be used until normal operation is restored by
opening and closing the door. If a door switch has failed, causing
"0 MINUTES" to remain in the display after the door is opened
and closed, it must be replaced before normal operation can be
restored.
COLD START (Initial first use) – Washer/dryer is programmed at
the factory as follows:
Washer 11-minute wash period
1.75 wash price (PD models)
0.00 wash price (PN models)
3 rinses (extra rinse not enabled)
Dryer 5 minutes per coin for PD models
45 minutes dry time for PN models
1.50 dry price (fixed cycle with top off – PD
Models)
0.00 dry price (fixed cycle – PN Models)
29