Electronic Control Setup Instructions - Maytag MHN33PDCWW Installation Instructions Manual

ELECTRONIC CONTROL SETUP INSTRUCTIONS

Washer Control
General Washer/Dryer User Information
NOTE: After the washer/dryer has been installed and plugged
in, the display will show "0 MINUTES" on the washer and dryer
portions of the display. After the washer and dryer doors have
been opened and closed, the display will show the price for each
machine. On washer/dryers set for free cycles, the display sections
will flash "SELECT CYCLE. "
1. PD Models: Insert coins until "SELECT CYCLE" flashes on the
display portion of the washer or dryer that is to be run.
PR Models: A debit card is required rather than coins.
Generation 1 or 2 debit card systems may be used; but
when the Generation 2 debit system is used, the controls
will automatically be set to Enhanced Debit mode (J. Ed). In
Enhanced Debit mode, the card balance will also display when
a debit card is inserted into the reader.
2. Door must be closed on the desired washer/dryer before cycle
selection is made.
3. Press the fabric setting button for the washer/dryer cycle desired.
After the cycle is started, the time will display and count down.
4. If a cycle is interrupted by opening the door or power loss,
"RESELECT CYCLE" will flash in the display. To restart the
washer/dryer, close door and reselect desired cycle.
NOTE: When set for free vend operation an ongoing dryer cycle will
cancel if the door is opened.
34
Dryer Control
Scrolling "OUT OF ORDER" Message, Followed by
a Failure or Diagnostic Code Showing in Display
This condition indicates the washer/dryer is inoperative. Diagnostic
codes being displayed on the upper portion of the display pertain
to the dryer section, and diagnostic codes displayed on the lower
portion of the display apply to the washer section. Diagnostic codes
displayed on both the upper and lower portions of the display
pertain to the control system of both the washer and dryer.
"0 MINUTES" Showing in Display
This indicates the cycle is complete and the washer/dryer cannot
be operated. Coins dropped or debit inputs during this condition
will be stored in escrow but cannot be used until normal operation
is restored by opening and closing the door. If a door switch has
failed, causing "0 MINUTES" to remain in the display after the door
is opened and closed, it must be replaced before normal operation
can be restored.
Cold Start (Initial first use)
Washer/dryer is programmed at the factory as follows:
Washer 11-minute wash period
$1.75 wash price (PD models)
$0.00 wash price (PR models)
3 rinses (extra rinse not enabled)
Dryer 5 minutes per quarter for PD models
45 minutes dry time for PR models
$1.50 dry price
(fixed cycle with top off – PD Models)
$0.00 dry price
(fixed cycle – PR Models)