Setting Dialing Parameters; Making Calls With The; Figure 14 - Dialing Parameters Screen - Polycom VIU-323 User Manual

Terminal adapter

Table of Contents

Selecting the VIU-323 for Configuration

Setting Dialing Parameters

In the Dialing Parameters screen, type the 2nd number delimiter and the default bandwidth.

The Dialing Parameters screen displays the following parameters:

Physical STD – displays the data interface standard, which is V.35.

Dialing STD – displays the dialing standard, which is RS366.

2nd Number Delimiter – for use with two-channel (2B) calls only. Options are asterisk (*),

pound (#) or None. This delimiter must match the 2nd Number delimiter defined for the

gateway. This delimiter differentiates between the two telephone numbers used to dial two-

channel (2B) calls (note that if the phone number is the same for both channels, type the

phone number once followed by the delimiter). We recommend setting the 2nd Number

Delimiter as * because the VIU-323's dialing prefix delimiter is preset as #.

Codec Type – displays the communications standard used by the room system the VIU-323

is connected to; this value is always H.320 and cannot be changed.

Outgoing Default Bandwidth – displays the default bandwidth of calls made from the

room system (via the VIU-323). You can change this setting when dialing by adding a

prefix to the dialing stream; see "Making Calls with the VIU-323."

Incoming Default Bandwidth – displays the default bandwidth of calls received by the

room system (via the VIU-323). Remote VIU-323's that call into the VIU-323 can force this

5-11

Table of Contents

Do you have a question about the VIU-323 and is the answer not in the manual?