Polycom ViewStation EX Release Note page 5

Release Notes
ViewStation EX/FX/VS4000, Version 6.0.5
Feature Limitation
Telnet/API
User Interface
V.35
Communication
Video
Web Interface
During a Telnet session with the system, the reboot
command prompted the user with the "reboot, are you sure
<y,n>" prompt. If the user entered a capital 'Y' or 'N', the
system would respond with a "command not found"
message. This has been corrected.
When in an audio-only conference, the main monitor
toggles between near video and the main screen to prevent
the potential of burn in. You can stop this behavior by
preventing the system from going to sleep. Use ftp to put a
file on the system named "sleeponnear.dat" with the word
"No." An alternative way to prevent the system from going
to sleep is to send the API command
to set this file.
When the MGC was used for a conference and one of the
sites terminated its call, the other sites would see the
message "Join to Conference." This has been corrected.
When a system was set up as a direct connect V.35
system, and the user selected Display Dialing Protocol
on the Dialing Preferences screen then rebooted the
system, the selection was no longer selected. This has
been corrected.
A V.35 Direct Connect system had a problem connecting
properly and displaying video at a call speed of 1536 with
a NEC system. This has been corrected.
Video would freeze in a three-way or four-way internal
multipoint conference making all H.323 calls. This has
been corrected.
The user could create an address book entry with two
entries on a system which was configured as an IP-only
system and each entry had an IP address only with the call
speed set to 384K. If the user selected this address book
entry and made the call from the Web, a popup box
displayed "The system is not configured to support ISDN
calls." When the user clicked OK, the system dialed the call
properly. This has been corrected.
The system was not dialing properly when using the web
interface to dial calls through a gateway on an IP-only
system. This has been corrected.
- 5 -
sleeponnear no