Advertisement
2
SETUP
2.1
Unpacking and setting up the vehicle
–
Remove straps and box.
S00694-10
–
Remove the adhesive tape in the upper area of the motorcycle.
S00695-10
–
Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking, leave the other films
on the vehicle until you have finished work on the vehicle.
–
Remove the separate enclosure and unpack it. Check the separate enclosure for
completeness.
–
Check the vehicle for transport damage.
S00696-10
–
Remove the controls from the transport holder.
–
Remove the screws and handlebar clamps.
–
Remove the transport holder.
S00697-10
–
Remove the right hand guard.
–
Position the controls on the right half of the handlebar. Tighten the screws.
Guideline
Remaining screws, chassis
Remaining chassis screws
–
Mount the right hand guard.
M00791-01
–
Position the handlebar.
–
Position the handlebar clamps. Tighten the screws evenly.
Guideline
Screw, handlebar clamp
The markings
dlebar clamps.
Markings
S00698-10
of the handlebar scale are located centrally between the han-
face backwards.
M5
5 Nm (3.7 lbf ft)
M6
10 Nm (7.4 lbf ft)
M8
20 Nm
(14.8 lbf ft)
3
Advertisement
