Outstanding Issues - Polycom SoundPoint IP 300 Release Note

Release Notes - SIP Application

3.3 Outstanding Issues

The following issues will be fixed in a subsequent release.
• 4310: No QoS support for signaling protocol (TCP)
Workaround: The default QOS parameters will still be used for TCP signaling
packets, and these may be specified in the sip.cfg configuration file.
• 5085: Cannot answer an incoming call while directory is being saved
Workaround: None.
• 6527: Shared line does not ring if incoming call arrives when phone is playing
dialtone then subsequently hangs up
Workaround: None.
• 8532: Subnet mask forces all packets through gateway when not using DHCP
and when using the wrong subnet mask for the network class in use, for
example using 192.168.X.X addresses with a 255.255.0.0 subnet mask
Workaround: Use the correct subnet mask.
• 8547: Local ringback is not played if far end does blind transfer without going
on hold
Workaround: None.
• 8921: Centralized conference fails due to RTP port being slow to open in some
cases
Workaround: None.
• 9176: Memory leak in phone if it tries to upload log files into a non-existent
folder which is specified by LOG_FILE_DIRECTORY
Workaround: Specify a valid folder destination in LOG_FILE_DIRECTORY.
• 9292: IP 4000 reboots upon downloading a wave file with a path containing '\'
instead of '/'
Workaround: Wave file paths must be specified using '/' e.g. "wavs/ring1.wav".
• 9709: RTCP not sent or received when calls are on hold
Workaround: None.
• 11588: The local contact directory feature cannot be disabled
Workaround: None.
• 12155: SoundPoint IP 300 and 301 phones have no "Exit" softkey during the
ACD login process
Workaround: Exit the display by pressing the Menu key or lifting and replacing the
handset.
• 12455: On SoundPoint IP 601 phone, per-contact directory settings such as
auto-divert do not work for calls arriving on lines 7 to 12
Workaround: None.
• 12492: SoundPoint IP 601 phone with Expansion Module(s) attached may fail
to load the selected language after rebooting
Workaround: Switch to English (Internal) and then back to the desired language after
the reboot.
Copyright © 2006 Polycom, Inc.
Notes
Page 25