Table of Contents
Advertisement
MANURE SPREADER
MANURE SPREADER
MANURE SPREADER
MANURE SPREADER
MANURE SPREADER
OPERA
OPERA T T T T T OR'S MANU
OPERA
OPERA
OPERA
Revision #00
3123 Starting Serial #613604
3127 Starting Serial #614341
H&S MANUFACTURING CO.,INC.
P.O. BOX 768 (715) 387-3414 FAX (715) 384-5463
3123/3127
3123/3127
3123/3127
3123/3127
3123/3127
OR'S MANU
OR'S MANU
OR'S MANU AL
OR'S MANU
WARNING
Manufactured By
MARSHFIELD, WISCONSIN 54449
Heavy Duty
Spreader
READ AND UNDERSTAND THIS MANUAL
BEFORE OPERATING THIS EQUIPMENT.
UNSAFE OPERATION OR MAINTENANCE OF
THIS EQUIPMENT CAN RESULT IN SERIOUS
INJURY OR DEATH.
HSMFG1215
AL
AL
AL
AL
Part #75897
Advertisement
Table of Contents
Related Manuals for H&S 3127
Summary of Contents for H&S 3127
- Page 1 UNSAFE OPERATION OR MAINTENANCE OF THIS EQUIPMENT CAN RESULT IN SERIOUS WARNING INJURY OR DEATH. Revision #00 3123 Starting Serial #613604 HSMFG1215 Part #75897 3127 Starting Serial #614341 Manufactured By H&S MANUFACTURING CO.,INC. P.O. BOX 768 (715) 387-3414 FAX (715) 384-5463 MARSHFIELD, WISCONSIN 54449...
-
Page 2: Table Of Contents
CONTENTS Warranty & Warranty Registration Card ..........1-2 Manufacturer’s Statement . -
Page 5: Dealer Pre-Delivery Checklist
DEALER PRE-DELIVERY CHECK LIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS After the Manure Spreader has been completely set-up, check to be certain it is in correct operating order before delivering to the customer. The following is a list of points to inspect. Check off each item as you have made the proper adjustments and found the item operating satisfactorily. - Page 6 Intentionally Left Blank...
-
Page 7: Dealer Delivery Checklist
DEALER DELIVERY CHECK LIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS This check list that follows is an important reminder of valuable information that should be passed on to the customer at the time this Manure Spreader is delivered. Check off each item as you explain it to the customer. - Page 8 Intentionally Left Blank...
-
Page 9: Safety Information
SAFETY INFORMATION YOUR SAFETY ALERT! IS INVOLVED. THIS SYMBOL IS USED THROUGHOUT THIS BOOK WHENEVER YOUR PERSONAL SAFETY IS INVOLVED. TAKE TIME TO BE CAREFUL. REMEMBER: THE CAREFUL OPERATOR IS THE BEST OPERATOR. MOST ACCIDENTS ARE CAUSED BY HUMAN ERROR. CERTAIN PRECAUTIONS MUST BE OBSERVED TO PREVENT THE POSSIBILITY OF INJURY OR DAMAGE. -
Page 10: Safety Information
SAFETY INFORMATION Keep signs in good condition. Immediately replace any missing or damaged signs. RECOGNIZE SAFETY INFORMATION This is the safety-alert symbol. When you see this symbol on your machine or in this manual, be alert to the potential for personal injury. Follow recommended precautions and safe operating practices. -
Page 11: Safety Decals
SAFETY INFORMATION... - Page 12 SAFETY INFORMATION -10-...
-
Page 13: Safety Information
SAFETY INFORMATION TRACTOR: This operators manual uses the term “Tractor” when identifying the power or the towing source. W A R N I N G TO PREVENT SERIOUS INJURY OR DEATH BEFORE YOU ATTEMPT TO OPERATE THIS EQUIPMENT, READ AND STUDY THE FOLLOWING INFORMATION. -
Page 14: Cap Screw Torque Values
-12-... -
Page 15: Set-Up & Assembly
SET-UP & ASSEMBLY Note: Determine right and left side of spreader by viewing it from the rear. If instructions or parts lists call for hardened bolts, refer to Cap Screw Torque Value page to identify. PREPARING MANURE SPREADER The Manure Spreader may be shipped without the wheels/tires installed. 1. -
Page 16: Preparing For Operation
PREPARING FOR OPERATION TRACTOR CONNECTIONS Tractor Hitch 15-3/4” for 1000 RPM Fasten the spreader hitch to the drawbar with a hitch pin with a safety locking device. Remove the weight from the jack (jack is not to be used when spreader is loaded). Remove jack from pipe mount and place on convenient storage mount located on... -
Page 17: Operation
OPERATION EMERGENCY SHUTDOWN If a foreign object becomes lodged in the beater area and shears the shear bolt, disengage the PTO. Stop the tractor engine, remove the ignition key, and allow all mechanisms to stop before cleaning or working on the spreader. WARNING: Some photographs used in the following pages show guards or shields removed for clarification. -
Page 18: Adjustments
ADJUSTMENTS DRIVE CHAIN To adjust front drive chain, turn nut on adjustingrod (located at the right hand front side of spreader) clodkwise. There should be 1/2” deflection at the center of the drive chain. Over tightening or too loose of a chain will result in excessive wear on the bearing, chain and sprockets. - Page 19 ADJUSTMENTS APRON 1. Adjust the apron by loosening the mounting bolts on the chain slides on the outside of the frame. Mounting bolts shown in the drawing. 2. Tighten the adjusting bolts until the apron chain clears the underside of the axle by 1 inch. 3.
-
Page 20: Service
SERVICE SHEAR BOLTS - Main Drive The beater and the apron drive are protected by one shear bolt located on the front end of the side drive shaft (left side of spreader). Two spare shear bolts are provided. Shearing of the bolts is normally due to foreign objects in the manure or starting the spreader PTO too quickly with high tractor RPM’s. - Page 21 SERVICE BEATER Periodically inspect the beater for wear or damage. Replace damaged or worn beater blades. Always use H&S special grade 5 bolts, washers, and nuts when replacing blades. Torque bolts to 60 ft. lbs. Consult with your local H&S dealer for additional ordering information. WHEEL BEARING LUBRICATION, CLEAN &...
-
Page 22: Optional Equipment
OPTIONAL EQUIPMENT REAR PAN The rear pan shown below is optional equipment. TOP BEATER The top beater shown below is optional equipment. 2nd HYDRAULIC ENDGATE CYLINDER Your manure spreader is equipped with brackets to accept an optional second cylinder to raise and lower the hydraulic endgate. -
Page 23: Lubrication Guide
LUBRICATION GENERAL INFORMATION IMPORTANT: Catch and dispose of fluid per local waste disposal regulations whenever service is performed on hydraulic components, valves, cylinders, hoses, etc. GREASE FITTINGS There are numerous grease fittings on your manure spreader. If these are lubricated properly and often enough, it will prolong the life of the spreader. - Page 24 LUBRICATION GREASE ZERK LOCATION - Grease every 10 Hours A. (3) PTO Shaft B. (2) Front jack shaft bearings. C. (2) Side shaft on S3123 (4) Side shaft on S3127 D. (2) Rear drive shaft (LH is a remote fitting) E.
-
Page 25: Decal Location
Warning - Help Avoid Injury 72479 Warning - Do Not Operate if Decal is Exposed 82602 Warning - Crushing Hazard 82793 Beater/Apron Control 093020 9/3123 - 11/3127 Grease Zerk 093466 540 RPM 111593A Danger - Stay Clear of Beater 111593C... -
Page 26: Decal Location
DECAL LOCATION 72100 - S3123 72097 72101 - S3127 (S3123/S3127) 54033 9194B 72203A 1494J 1494B DCAMB 82602 66076 1494B 093466 1494L 11599 093020 82793 71494A 71494A 71188B 9194A 66076 1494K DCAMB 12794 (under shield) 1494A 1494K 82793 1494A 093020 111593C DCAMB 111593A 66076 72098 - S3123... - Page 27 DECAL LOCATION 72100 - S3123 72097 72101 - S3127 (S3123/S3127) 54033 72203A 9194B 1494B 11599 82793 72095 (S3123/S3127) 72098 - S3123 72099 - S3127 1494B 9194A DCAMB 1494J 1494A 11211176 093020 DCRED 11593A 093020 111593C Optional Upper BeaterShield 1494H 1494J 1494A (UNDER SHIELD)
-
Page 28: Trouble Shooting
TROUBLE SHOOTING WARNING: MAKE SURE THAT THE TRACTOR IS SHUT OFF AND THE SPREADER CAN NOT MOVE BEFORE SERVICING THE MANURE SPREADER. MAINTENANCE AND REPAIR SERVICE WORK TO BE PERFORMED BY A QUALIFIED SERVICE PERSON ONLY. TROUBLE... POSSIBLE CAUSE... POSSIBLE REMEDY... Beater Does Not Turn PTO Not Turning Engage Tractor PTO... -
Page 29: Service & Parts Notes
SERVICE NOTES -27-... - Page 30 SERVICE NOTES -28-...
- Page 32 H&S MFG H&S MFG ..CO H&S MFG CO ..H&S MFG H&S MFG products approved for the FEMA FEMA FEMA FEMA FEMA SEAL OF Q SEAL OF Q U U U U U ALITY SEAL OF Q ALITY ALITY...