Polycom iPower 600 Installation Instructions Manual page 7

"dynamic FECC".
– The Polycom Version 4.0 MGC-50 and MGC-100 MCUs do not
support far-end camera control or browsing.
– DO NOT attempt to run versions of the Polycom MGC-100 MCU lower
than 2.2 with iPower Multimedia conferencing systems.
– You may experience poor quality when sending Content in a LAN call
using a Polycom MGC-50 or MGC-100 MCU running Version 4.00 or
lower. To address this issue, use version 4.01 of the Polycom MGC-
50 or MGC-100 MCU.
– You may experience problems with application sharing in a
conference using a Polycom MGC-50 or MGC-100 MCU running
Version 4.00 or lower. To address this issue, use version 4.01 of the
Polycom MGC-50 or MGC-100 MCU.
– When you use iPower Control Protocol to make calls from a LAN
system to an ISDN system:
All prefixes and suffixes required by the gateway must be
o
configured through AdminTools
The iCP Command must set the Calltype to Gateway
o
Polycom PVX Version 6.0.1
Polycom V500 Version 7.0.1
Polycom ViaVideo™ Version 5.1, 6.0.1
Polycom ViewStation 4000/EX/FX Version 6.0
Polycom ViewStation MP/SP Version 7.5.2
Polycom VSX 3000 Version 7.0.1
Polycom VSX 7000 Version 5.1.1, 7.0.1
Polycom VSX 8000 Version 7.0.1
RADVISION ViaIP ECS Gatekeeper Version 3.2
– RADVISION gatekeepers configured for H.245 gatekeeper-routed
signaling do not support calls from iPower systems. The gatekeeper
must be configured for direct signaling or for gatekeeper-routed
Q.931 signaling.
RADVISION BRI/PRI On-LAN L2W-323 Gateway Revision 2.2.3.25
– Calls through a RADVISION gateway at 2x64 kbps must include an
asterisk ( ) suffix to the number dialed. Without this suffix, the call
*
connects to the far end at 1x64 kbps.
RADVISION MCU-323/20 Version 2.2.1.0
Sony 6000 5.01
T120 does not work in H.320 calls with Sony PCS 6000.
Sony PCS1 2.01
iPower may received poor quality video in H.323 calls with Sony
PCS-1 that use H.263+. To work around this issue, configure the
Sony system for H.263 or H.264.
Tandberg 880 Versions E3.0 and E3.1