Polycom iPower 600 Installation Instructions Manual page 24

1. From the web browser, select Tools > Internet Options and click
Advanced.
2. Uncheck the check boxes for any other Java plug-ins.
Note: Netscape Navigator 6.0 does not display the Alarms and Statistics
pages.
You cannot save system configuration changes made using WebRemote
if Auto Logon is enabled and the Auto Logon password is blank. You
must change the Auto Logon name and enter a password.
Hardware
The iPower system is tested extensively with the hardware configuration
supplied as standard with this system. Polycom cannot warrant the
operation of the system if you replace or add your own hardware. Unless a
separate maintenance contract is in place, our technical support personnel
may request that you replace the original hardware to be able to
effectively isolate any problem. Please note that the software supplied to
install the operating system and the iPower collaboration software will not
reflect any user-installed hardware.
In some environments, the drivers for iPower 9000 system's Network
Interface Card may spontaneously uninstall. If this occurs, download
the new version of this the driver from Intel's web site.
If the Low Cost BRI card is replaced with another Low Cost BRI Card,
the ISDN Bandwidth settings are automatically set to 64K and all calls
are restricted to 64K. To make higher bandwidth calls, manually reset
the standard and premium bandwidths to a higher setting.
When you power on an iPower 9000 system with an iPower 70 camera,
the camera may take a few minutes to fully initialize. During this time,
you may see a camera readiness message. You do not need to take any
action. After the start-up period, the message disappears and the
system is ready to use.
The DVD drive in the iPower 9000 system reads CDs and data DVDs,
but it does not play video DVDs. If you try to install the software
required to play video DVDs, it may conflict with the iPower system's
video drivers. To address this issue, connect an external DVD player to
the iPower 9000 system just as you would connect a VCR.
On the iPower 9000 system, the VGA monitor connector labeled
(the second VGA output) is not supported.
3
When using a Hitachi™ CMP307XU or other native XGA display device,
change the resolution of the iPower system to 1024x768 for better
display quality.
If you are using any USB device, you must obtain and install the latest
Windows 2000 drivers from the manufacturer's web site.
Monitor