Advertisement
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
IPMItool (Linux/Mac)
command
For a full list of LOM commands supported by the Firepower system, see the
Configuration
Enable Lights-Out Management
You must be an Admin user to perform this procedure.
Before you begin
• Install an Intelligent Platform Management Interface (IMPI) utility on your local computer. See
• Determine which commands are needed to access an appliance using the IPMI tool. See
• Redirect console ouput to the serial port. See
• Disable Spanning Tree Protocol (STP) on any third-party switching equipment connected to the device's
Procedure
Step 1
In the FMC web interface, choose System > Configuration, then click Console Configuration.
Step 2
For Console, choose Lights Out Management.
Step 3
Choose the address Configuration for the the system (DHCP or Manual).
Step 4
If you chose manual configuration, enter the necessary IPv4 settings:
• Enter the IP Address to be used for LOM.
• Enter the Netmask for the system.
• Enter the Default Gateway for the system.
ipmiutil (Windows)
command
Guide.
Utility Installation, on page 42
on page 42
for more information.
management interface.
Note
The LOM IP address must be different from and in the same subnet as the FMC management
interface IP address.
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
Description
The command you want to issue to the
appliance. Note that where you issue the
command depends on the utility:
for more information.
Redirect Console Output, on page
Enable Lights-Out Management
• For IPMItool, enter the command last:
ipmitool -I lanplus -H IP_address -U
username command
• For ipmiutil, enter the command first:
ipmiutil command -V4 -J3 -N
IP_address -U username -P password
Firepower Management Center
LOM Commands,
44.
IPMI
43
Advertisement
