Advertisement
Generate a Classic License and Add it to the Firepower Management Center
after you have registered them to the FMC by editing the device's general properties. For more information,
see the
To add classic licenses after completing initial setup, for each license:
• Generate the license and add it to the FMC.
• Assign the license to a managed classic device.
Generate a Classic License and Add it to the Firepower Management Center
Before you begin
• Confirm you have access to the Cisco Product License Registration Portal at https://cisco.com/go/license.
• Review the information about types of Classic licenses in the
• Purchase a product authorization key (PAK) for each license, and service subscriptions if any are needed.
Procedure
Step 1
Choose System > Licenses > Classic Licenses > Add New License.
Step 2
Note the value in the License Key field at the top of the Add Feature License dialog.
Step 3
Click Get License to open the Cisco License Registration Portal.
Step 4
Generate a license from the PAK in the License Registration Portal. For more information see
https://slexui.cloudapps.cisco.com/SWIFT/LicensingUI/Home. This step required the PAK you received when
you purchased the license, as well as the license key from the FMC.
Step 5
Copy the license text from either the License Registration Portal display, or the email the License Registration
Portal sends you.
Important
Step 6
Return to the Add Feature License pages in the FMC web interface.
Step 7
Paste the license text into the License field.
Step 8
Click Verify License.
Step 9
Click Submit License.
What to do next
When you add Firepower classic managed devices to the FMC, select the appropriate licenses to apply to the
devices. See
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
34
Firepower Management Center Configuration Guide
Guide
for your version to determine what type of Classic license you need and whether you also need
to purchase service subscriptions for the features you plan to use.
The licensing text block in the portal or email message may include more than one license. Each
license in bounded by a BEGIN LICENSE line and and END LICENSE line. Make sure that you
copy and paste only one license at a time.
Add Managed Devices to the FMC, on page
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
for your version.
Firepower Management Center Configuration
38.
Advertisement
